Скачать: CL | DM;

Out of synchronization in MCK   Найти похожие ветки 

← →
Boguslaw   (2003-12-27 12:57) [0]

Hello,

I have strange problem with on of my programs (rather large) in KOL. I discovered that project is out of synchronization between VCL and MCK - so any of UnitX_X.inc is not updated anymore ! Could You give me a solution ? I checked and Locked property is set to false.I would add some controls to my KOL forms but by hand is impossible becouse from time to time UnitX_X.inc files are reconstructed (but not all the time) I"m using Delphi 5 Std with KOL 1.89.

Best Regards
Boguslaw

---

← →
Gandalf ©   (2003-12-27 13:15) [1]

Иногда такое бывает, говорят дело в кривых MCK контролах, лечилось удаление контров до тех пор пока не станет внось генериться код и установкой их по новой...

---

← →
Boguslaw   (2003-12-27 15:12) [2]

Thank You. I figure it. I just create console mode application and paste all lines from my old dpr and include files into it (this way  I create a fresh dpr file without reincluding forms) After opening of project all UnitX-X.inc were recreated and I must only set search paths and some other project options.
This MCK bug is probably another reason to incorporate all MCK code into some IDE with  form designer. I know that BloodShed software are planning to support designers in they DeVC++, but DEvPas is abandoned anyway (maybe Licence issue ? - could someone create GPL-ed IDE for Pascal using Delphi?).

Best Regards
Boguslaw Brandys

---

← →
Gandalf ©   (2003-12-28 13:27) [3]

Скорее это повод еще раз всем свой MCK код проверить, хотя  порой там твориться что-то странное, я векоторых проектах - обложив их всех try finally (MCK код контрлов) - так и не смог найти причину блокировки.

---

Страницы: 1 вся ветка

Скачать: CL | DM;



Память: 0.45 MB
Время: 0.022 c